ioMirror E3210 Series

Direct Input-to-Output Communication over IP ioMirror E3000 Ethernet I/O products are designed as a cablereplacement solution that connects remote digital input signals to output signals over an IP network. The ioMirror E3210 provides 8 digital input channels, 8 digital output channels, and a 10/100M Ethernet interface. 

Up to 8 pairs of digital input and output signals can be exchanged over Ethernet with another ioMirror E3210, or can be sent to a local PLC or DCS controller. Over a local area network, the ioMirror can achieve a low signal latency (typically less than 20 ms). With ioMirror, remote sensors can now be connected to local controllers or display panels over copper, fiber, or wireless Ethernet infrastructures. Signals can be transmitted over virtually unlimited distances, without noise problems.Split Sensor Signals to 16 Different Locations The ioMirror E3000 can split one input signal to two digital output channels at two different IP addresses. 

Eight tank level signals can be monitored at 16 different display panels, all at the same time. Local Alarm and Remote Alarm Messages for Monitoring Connectivity The ioMirror E3210 has a 24 VDC alarm output channel that can activate an attached buzzer or LED display when the connection fails. In addition, both ioMirror modules can send messages to the ioEventLog software, ensuring that at least one of the warning messages will reach the ioEventLog software.

Ethernet
1 x 10/100 Mbps, RJ45

Protection

1.5 KV magnetic isolation

Protocols
Modbus/TCP, TCP/IP, UDP, DHCP, Bootp, HTTP, SNTP

Channels
8, source type

Sensor Type
NPN, Dry contact

Dry contact
Logic 0: short to GND
Logic 1: open

Wet Contact
Logic 0: 0 to 3 VDC
Logic 1: 10 to 30 VDC (DI COM to DI) 

Channels
8, sink type, 36 VDC, 200 mA

I/O Mode
Digital Output

Isolation
3K VDC or 2K Vrms

Power Input
24 VDC nominal, 12 to 48 VDC

DO Power
24 VDC nominal, up to 45 VDC

Wiring
I/O cable max. 14 AWG